Untitled DocumentSpecifications of 8 Series LiFePO4 Batteries Charge & Discharge Guard ShieldApplication:The product could be widely used in the fields of electric vehicles, standby power supply and power supply of military equipment, etc.Main Functions:The product has 5 main functionsover charge, over discharge, over current, short circuits and balancing. Function of over charge protectiononce voltage of any battery in the group gets higher than the over charge protection point, charge cuts off to ensure all batteries work within the over charge protection point. Function of over dischargeonce voltage of any battery in the group gets lower than the over charge protection point, discharge cuts off to ensure all batteries work beyond the over charge protection point. Function of over currentduring the discharge process of battery group, once discharge current gets over the set over current protection point, output cuts off to ensure battery group works within the safe limit of current. Function of short circuit protectiononce battery groups output port appears the condition of short circuit, it cuts off to ensure battery group not to be damaged because of short circuit. Function of voltage balancingin the late charging period of battery group, voltage difference that appears during the using process of each battery could get balancing revised to ensure battery groups capacitance.Specified TypesYS80301 Technical Index Item 8series balancing guard shieldOvercharge protection (V)3.95??0.025 Overcharge recovery (V)3.80??0.05 Overdischarge voltage (V)2.2??0.1 Overdischarge recovery (V)Cutload or chargeNormalworking current (A)30Overcurrent protection (A)60Internalresistance ??(??m/ohm)<30Chargingbalancing current (mA)60Chargingbalancing voltage (V)3.63??0.03 Overcharge postpone time (mS)1.2Overdischarge postpone time (mS)144Temperatureprotection ( )65 (option) Temperaturecharacteristic??1.0mv/Workingtemperature????????( )-10~+60Storagetemperature??????????( )-30~+85Powerloss (uA)<400 (Vn=3.2v normal)<200 (Vn2.2v Under-voltage) Dimensions (mm)94 x 60 x 7Weight(gram)62 Download Installation guide here.Usage and Attention After purchasing the protection mould, users should connect lines in compliance with the instruction. Voltage usually exists in the battery, so operators should peel one line and then connect another starting from B-. Lines should be connected from the low position to the high position with no mistake of order, or the irreparable damage could be caused. When lines get connected, bits of copper and tin should not cling to the guard shield. Protection board should be connected to battery group with compliance to specifications and any leading line should not be put on the back of the board but on the lateral side. When equipping the guard shield, hard epoxy sheer should be fixed on the back of the board as the barrier to prevent the squeezing against short circuit. When welding ou